Structalath Twin Trac is an innovative reinforcing lath that simplifies the attachment of lath to wood and steel studs. It is excellent for commercial construction; Twin Trac has all the great features of regular Structalath with the addition of eight secondary cold-rolled longitudinal wires that add strength to form a 'track' for convenient attachement. Twin Trac can be substituted wherever 2.5 metal lath has been specified.

Innovative Design

• Twin Trac is the only welded wire lath specifically designed to meet the challenges faced by the commercial lathing contractor

• Designed to provide for easy attachment for both steel and wood stud construction

• Longitudinal wires create a series of eight - 3/16" spacing bands which act as a continuous washer. This allows the easy penetration of self tapping screws, hand nails and a flat base for automatic staples

• Flat wires provide a pressure seal at the fastener point that serves to inhibit water leakage

• Provides a minimum of 28 rugged furring points per square foot that ensure superior embedment and crack resistance

Economical

• Twin Trac in rolls (compared to sheet) provides the most economical and cost effective metal base for three coat stucco for commercial and residential construction projects

• Saves material at side and end laps compared to metal lath sheets. The reduction of overlaps means less weak point therefore less shrinkage cracks.

• Reduced call backs

Convenient

• Worker friendly Twin Trac unwinds from the roll into the flat without curvature memory

• Convenient and simple installation

• Designed to minimize build-up at horizontal laps. Note: Lapping details available in PDF on right sidebar.
  

• Easy to manage on scaffold, reducing worker fatigue